Ground Control Spec E46 Racing Caster / Camber Plates

Ground Control Spec E46 Racing Caster / Camber Plates

PLEASE NOTE GROUND CONTROL IS VERY BUSY AT THIS TIME. SOME OF THEIR ITEMS ARE EXPERIENCING EXTENDED LEAD TIMES. WE THANK YOU FOR YOUR PATIENCE AND UNDERSTANDING.

$461.00

Lead Time May Vary, Please Call.

 

Ground Control racing caster / camber plates. Not intended for Street use. 

Will not work with the stock springs, only specified I.D. springs.

This is a clean page design, and allows more camber and caster adjustment than any other camber plate available without modifying the strut towers. Within the SCCA rules, it is illegal to bend, cut or reweld the struts for more negative camber, so this is the legal way to go fast.

Ground Control Racing Camber / Caster Plates offer more features than most.

  • More camber adjustment than stock
  • Caster adjustment
  • Aircraft grade bearings
  • Engraved tops with calibrated degree marks
  • Steel reinforcements

This is a very well engineered product. Every component is anodized or plated, including all fasteners. GC tops are a low profile design, and add extra travel to avoid excessive bottoming out.  The priority of this strut top design is to allow fast, repeatable alignment changes at the track.

Ground Control Racing Camber / Caster Plates More camber adjustment than stock, caster adjustment, aircraft bearings, engraved with calibrated degrees, with stainless steel reinforcement. Every component is anodized or plated, including fasteners. Adds extra travel to avoid excessive bottoming out, this is a very well engineered product. The stainless steel reinforcement prevents electrolysis between the steel fender and the aluminum camber plate.

Camber and caster are separately adjustable by sliding the mounts, without removing any components from the car. The priority of this design is to allow fast, repeatable alignment changes at the track.

The Ground Control camber plates feature two sets of bearings, a proprietary bearing, made to our specs by Aurora in the USA, which allows for articulation of the shock shaft. This spherical bearing is very under-stressed, as the Ground Control design does NOT support the weight of the car on the spherical bearing. Instead, the weight of the car is supported by a completely separate articulating needle bearing, which is also manufactured for Ground Control in the USA. Will not fit stock springs.