Race Spec E46 Exhaust

Exhaust Magnaflow Race Spec E46 Exhaust System Full Package from Bimmerworld

Our lightweight, high-quality stainless exhaust system sets the standard for maximizing power from your E46 6-cylinder non-M track machine. Easy bolt-on installation. This is the required exhaust for all cars running in Spec E46. Kit includes Y-Pipe required for integration into E36 OBDII headers.

Our BimmerWorld E46 Exhaust System by Magnaflow is the only choice when you want the most power out of your Non-M E46 track or race car. The stock twin-pipe (or even single in some models) configuration simply doesn’t cut it. We see a lot of cars that have transitioned from street to dedicated track use, and while they have nice aftermarket rear mufflers and even center sections without cats, those lighter-than-stock systems may be nice for street cars, but the design limits the power and performance of your car. Great street performance parts don’t always make great race parts, and we can often do much better with a dedicated track design.

The BimmerWorld E46 Non-M Race Exhaust System by Magnaflow is made of thinner-walled stainless 3″ single pipe to significantly reduce weight, even when compared to stainless aftermarket street parts. The 3″ configuration also serves to maximize horsepower output as accelerating in traffic won’t be a concern when you’re wringing out the engine at the racetrack.

This exhaust system includes both a mid-section resonator and straight pipe option, allowing you to reduce or increase volume as needed to meet sound limits. With the resonator installed, volume will typically be acceptable for more highly-restricted tracks such as Laguna Seca and Lime Rock, but environmental conditions and results may vary. V-band clamps are used throughout the system to make swapping out pieces or dropping the exhaust for maintenance or trackside repairs fast and easy – once installed, this exhaust can come off for typical work in minutes.

Included Y-pipe bolts directly to your self-supplied stock E36 exhaust manifolds, which remove the catalytic converter from your car without cutting and welding of your stock E46 parts. One O2 port is included for running a wideband sensor for data. The original post-cat O2 sensors can be removed, per Spec E46 rules and software tune. Our Y-pipe uses a proper racing merge collector, with primary legs designed in combination with factory E36 exhaust manifolds to simulate an equal-length header, which times exhaust pulses for improved scavenging and increased power.

Installation uses factory mounting points – necessary hardware included. E36 exhaust manifolds required and not included.

Catalytic converters not included – off-road use only.

Made in USA

Notice of Emissions Non-Compliance. Removing, disabling, or altering emissions equipment on a pollution-controlled road vehicle is illegal. Installing devices or software that trick, disable, or modify emissions controls and monitors on a pollution-controlled road vehicle is also illegal. This product is sold only for racing, competition, track, hobby, or other off-road use. It’s use is prohibited in any motor vehicle that is subject to emissions inspection or control. Legal in California only for racing vehicles that may never be used, or registered or licensed for use, upon a highway. Informations maybe requested for product use verifcation, before the item will be shipped.

BMW Fitments:

3 Series
E46 (99-00) > 323i
E46 (01-05) > 325i
E46 (01-06) > 325ci
E46 (99-00) > 328i
E46 (01-05) > 330i
E46 (01-06) > 330ci